ICND2 Lab 2-1, Task 2步驟說明

[從 Step 1 開始]

SwitchA# conf t
SwitchA(config)# int fa0/11
SwitchA(config-if)# switchport mode trunk
SwitchA(config-if)# end
SwitchA# show int fa0/11 switchport

Name: Fa0/11
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Administrative Native VLAN tagging: enabled
Voice VLAN: none
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan: none
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL

Protected: false
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Appliance trust: none

SwitchA# conf t
SwitchA(config)# int vlan 1
SwitchA(config-if)# ip addr 10.1.1.20 255.255.255.0
SwitchA(config-if)# no shut
SwitchA(config-if)# end
SwitchA# ping 10.1.1.3

Sending 5, 100-byte ICMP Echos to 10.1.1.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

SwitchA#