ICND2 Lab 4-1, Task 2步驟說明

[從 Step 1 開始]

RouterA# conf t
RouterA(config)# no ip route 0.0.0.0 0.0.0.0 10.2.2.3
RouterA(config)# end
RouterA# show int serial 0/0/0

Description:
MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
  reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters 4d03h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
  Conversations  0/0/32 (active/max active/max total)
  Reserved Conversations 0/0 (allocated/max allocated)
  Available Bandwidth 96 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
  0 packets input, 0 bytes, 0 no buffer
  Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
  0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
  0 packets output, 0 bytes, 0 underruns
  0 output errors, 0 collisions, 1 interface resets
  0 output buffer failures, 0 output buffers swapped out
  0 carrier transitions
  DCD=down  DSR=down  DTR=down  RTS=down  CTS=down

RouterA# conf t
RouterA(config)# int ser 0/0/0
RouterA(config-if)# ip addr 10.140.1.2 255.255.255.0
RouterA(config-if)# no shutdown
RouterA(config-if)# end
RouterA# ping 10.140.1.1



RouterA# ping 10.1.1.3



RouterA# show ip route



RouterA# show controllers serial 0/0/0



RouterA# show controllers serial 0/0/1



RouterA# conf t
RouterA(config)# int ser 0/0/1
RouterA(config-if)# clock rate 64000
RouterA(config-if)# ip address 10.23.23.1 255.255.255.0
RouterA(config-if)# no shutdown
RouterA(config-if)# end
RouterA# ping 10.23.23.2



RouterA#